Gruba instrukcja - poprostu wszystko co potrzreba - polecam .
Tekstowy podgląd strony 10 (kliknij aby zobaczyć)
OPERATION
Move the Master Power switch (marked �Power� ¡) to the ��� (On) position. The HKTS 5 subwoofer will automatically turn itself on or go into Standby mode, depending on whether or not a signal is being sent to the HKTS 5 by your receiver or surround processor, and provided that the Auto/On switch � is moved to the left so that it is in the �Auto� position. When your receiver or amplifier is off, or is not sending program material to the subwoofer, the subwoofer will be in Standby mode and the LED ¢ on the amp panel will turn red. When the subwoofer senses an audio signal, it will automatically turn itself on and the LED ¢ will turn green. If the subwoofer does not sense a signal after approximately twenty minutes, it will automatically go into Standby mode.
� £
When the Auto/On switch � is switched to the �On� position, the subwoofer will remain on, whether or not program material is playing. If you will be away from home for an extended period of time, or if the subwoofer will not be used, switch the Master Power switch ¡ to the �Off� position.
¢
¡
Volume
Volume can be adjusted using the Subwoofer Level Control £, as shown below.
